Concrete Slab & Foundation Contractor in the Texas Hill Country

Concrete slab pricing in Texas typically runs from $6 to $12+ per square foot installed, depending on slab thickness, rebar schedule, site prep, and access. Hill Country sites with caliche or rock, and Gulf Coast sites needing fill or moisture barriers, sit on the higher end. Every quote is free and itemized — no surprises.

Yes — every quote is free and includes a pre-site visit. We measure the pad, check grading and access, and give you written, itemized pricing within one business day.

Most residential and light-commercial slabs are 4 inches thick as a minimum. Heavy loads — steel buildings, equipment pads, RVs — often call for 5–6 inches with thicker footings or a grade beam. We design the slab for the load and the soil.

A monolithic slab is poured as one continuous piece: the footer, stem wall and slab are all wet concrete at the same time. It’s faster, stronger and a common choice for barndominiums, metal buildings, shops and garages in Texas.

All standard slabs are 3,000+ PSI, reinforced with #3 / #4 rebar at proper on-center spacing. Higher-strength mixes, fiber additives and post-tension options are available for engineered foundations and heavy industrial pads.

Yes — we reinforce with #3 or #4 rebar on a calculated grid. Rebar controls cracking and adds load capacity far better than wire mesh for the weight of buildings, vehicles and equipment.

Crack control comes from a stable, compacted base, proper rebar, control joints cut at the right spacing, the right mix for the climate, and proper curing. We also account for Hill Country caliche and expansive clay movement.

Yes — metal-building foundations and barndominium pads are core services. We engineer the slab with the correct thickness, footings, anchor-bolt layout and any brick ledges or rough-ins your builder needs.

Yes. We pour reinforced driveways with proper drainage and contraction joints, plus backyard patios and porches with clean finishes and the right slope for water runoff.

Standard broom finish, smooth steel-trowel finish, exposed aggregate, and stamped or stained decorative finishes for patios and driveways. We match the finish to the job’s use and look.

Yes. Our crews are set up for caliche, limestone shelf rock and rocky Hill Country lots with the right excavation, rock-saw work, fill and compaction. We engineer the base so the slab stays flat and crack-resistant over the life of the build.

Yes — we pour across Gulf Coast clay, North Texas blackland clay and South Texas expansive soils. We adjust slab thickness, rebar schedule and footings for soil movement, and engineer drainage so water doesn't sit against the foundation.

Permit requirements vary by county, city and project type. For most residential outbuildings and rural properties no permit is needed; for homes, ADUs or commercial work the city usually requires one. We can guide you through the local requirements.

Yes — site prep is part of our process. We clear, grade, excavate, bring in fill and compact the base before forms and rebar go in. You don't need to hire a separate dirt contractor.

From quote acceptance, most residential and light-commercial slabs schedule within 2–4 weeks. Forming, rebar and the monolithic pour are typically completed in 1–3 days on site; concrete reaches initial strength in 24–48 hours and full design strength at about 28 days.

You can typically frame walls in 3–7 days. Heavy loads — steel buildings, equipment, vehicles — should wait until the slab has cured to design strength (about 28 days). We'll advise the exact timing based on mix design and weather.

We serve the entire Texas Hill Country and major metros — Austin, Round Rock, Cedar Park, Leander, Georgetown, San Antonio, New Braunfels, Houston, Katy, The Woodlands, Dallas, Plano, Frisco and rural South Texas (Cuero, Victoria, Yoakum, Goliad). Our standard service radius is 100+ miles from Kerrville; longer trips are quoted with travel.

Inside our standard 100-mile service radius there's no extra travel charge. For Houston, DFW and far South Texas projects we quote travel and mobilization transparently in the written estimate — no hidden fees.

Yes — fully licensed and insured. Proof of insurance, references and prior pour photos available on request before you sign.